LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1023 (Clutch System -- F150 Pickup) >> Removal And Installation >> Bearing >> Installation

Removal And Installation: Bearing: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The input shaft pilot bearing can only be installed with the seal facing the transmission. The input shaft pilot bearing is pregreased and does not require additional lubrication.
    Fig 1: Installing New Input Shaft Pilot Bearing Using Special Tool
    G03964549Courtesy of FORD MOTOR CO.
  1. Using the special tool, install a new input shaft pilot bearing.
scientia non olet · About LEMON Manuals