Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Position the brake booster vacuum hose and bracket aside.
1. Remove the nut.
  - To install, tighten to 10 Nm (89 lb-in).
2. Disconnect the brake booster vacuum hose.
3. Position the brake booster vacuum hose and bracket aside.
Fig 1: Removing Brake Booster Vacuum Hose And Bracket
Courtesy of FORD MOTOR CO.
Detach the exhaust manifold-to-exhaust gas recirculation (EGR) system module tube from the exhaust manifold and the EGR system module and remove the tube.
- To install, tighten to 40 Nm (30 lb-ft).
To install, reverse the removal procedure.