LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1015 (Supplemental Inflatable Restraint System -- F150 Pickup) >> Removal And Installation >> Restraints Control Module RCM >> Installation

Restraints Control Module RCM: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the RCM and install the bolts.
    • Tighten to 12 Nm (9 lb-ft).
  2. Make sure the connector position assurance lever is in the full RELEASE position before attempting to connect the connector.
    Fig 1: View Of Connector Position Assurance Lever
    G03989905Courtesy of FORD MOTOR CO.
    3. CAUTION: Putting the large RCM electrical connector into the RCM on an angle can cause bad electrical connections and damage components.
    NOTE: The RCM has been removed for clarity.
  3. Position the large RCM electrical connector into the RCM.
      CAUTION: Do not push the connector on to where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the RCM before using the lever to fully seat the connector.
      Fig 2: Identifying Large RCM Electrical Wiring Connector
      G03903873Courtesy of FORD MOTOR CO.
    • With the large RCM electrical connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and a slight resistance is felt.
    4. NOTE: The RCM has been removed for clarity.
    Fig 3: Connecting Large RCM Electrical Connector
    G03987428Courtesy of FORD MOTOR CO.
  4. Connect the large RCM electrical connector.
    • Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
    • Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
  5. Connect the RESTRAINTS CONTROL MODULE RCM small electrical connector.
  6. If equipped, install the floor console. For additional information, REFER to INSTRUMENT PANEL AND CONSOLE .
  7. If equipped, install the 20 percent front seat cushion. Align the retainers on the 20 percent seat cushion and press down firmly near the front of the cushion to seat the retainers. For additional information, REFER to SEATING .
  8. Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM SRS DEPOWERING AND REPOWERING .
scientia non olet · About LEMON Manuals