Impact Sensors
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The restraints control module (RCM) orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system SRS has been involved in a collision in which the vehicle center tunnel area has been damaged, inspect the RCM mounting area for deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure the area of the RCM mounting is restored to its original condition.
WARNING:
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system SRS is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the sensor or any other damaged supplemental restraint system SRS components whether or not the air bag is deployed.
The RCM incorporates integral sensors that are not separately serviceable. All vehicles will have a front impact severity sensor located on the hood latch support bracket. The RCM is mounted on the center tunnel between the front seats. Mounting orientation is critical for correct operation of all impact sensors.