Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup, 2004 Ford Pickup, and 2003 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the battery. For additional information, refer to BATTERY .
- Release the 2 wiring harness locators from the battery tray.
- If equipped, unclip the vacuum reservoir and position it aside.
- Remove the 4 bolts and the battery tray.
- To install, tighten to 17 Nm (13 lb-ft).
- To install, reverse the removal procedure.