Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup, 2004 Ford Pickup, and 2003 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
- Remove the nut and position the starter solenoid positive cable terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).
- Remove the nut and position the starter solenoid wire terminal aside.
- To install, tighten to 5 Nm (44 lb-in).
- Remove the nut and position the starter motor ground cable terminal aside.
- To install, tighten to 22 Nm (16 lb-ft).
- Disconnect the battery cable harness locator on the RH engine mount.
- Remove the nut and position the battery cable lower bracket aside.
- To install, tighten to 25 Nm (18 lb-ft).
- Remove the bolt and position the battery ground cable frame terminal aside.
- To install, tighten to 30 Nm (22 lb-ft).
- Disconnect the battery cable harness locator on the generator bracket.
- Remove the nut and position the generator harness terminal and the CJB cable terminal (on the positive battery terminal) aside.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the bolt and position the battery ground cable body terminal aside.
- To install, tighten to 12 Nm (9 lb-ft).
- Disconnect the battery cable harness in-line electrical connector and remove the battery cable assembly.
- To install, reverse the removal procedure.