LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1010 (Interior Trim And Ornamentation -- F150 Pickup) >> Removal And Installation >> B-Pillar Trim Panel - Super Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door scuff plate.
  2. Remove the lower safety belt anchor bolt.
    • To install, tighten to 48 Nm (35 lb-ft).
  3. Remove the B-pillar trim cover.
  4. Remove the B-pillar bolt trim cover.
  5. Remove the B-pillar bolt.
  6. Remove the safety belt bolt cover.
  7. Remove the safety belt bolt.
    • To install, tighten to 48 Nm (35 lb-ft).
  8. Remove the rear seat backrest. For additional information, REFER to SEATING .
  9. Remove the pin-type retainer from the B-pillar trim panel.
    Fig 1: Removing Pin-Type Retainer From B-Pillar Trim Panel
    G03965975Courtesy of FORD MOTOR CO.
  10. Pull the safety belt through the B-pillar trim panel.
  11. Remove the B-pillar trim panel.
  12. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals