Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the rear axle speed sensor electrical connector.
- Remove the rear axle speed sensor bolt.
- To install, tighten to 15 Nm (11 lb-ft).
- Remove the rear axle speed sensor.
- To install, reverse the removal procedure.
NOTE:
Install a new O-ring before installing the rear axle speed sensor.