LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1007 (Anti-Lock Brake System -- F150 Pickup) >> Removal And Installation >> Wheel Speed Sensor - Front, 4x4 >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When removing the front disc brake components, never allow them to hang from the brake hose.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 4 wheel speed sensor harness retainers.
  4. Remove the 2 bolts and position the front brake caliper assembly aside.
    • To install, tighten to 112 Nm (83 lb-ft)
    5. NOTE: Match mark the front disc brake rotor and front wheel hub flange before removing the front disc brake rotor.
  5. Remove the brake disc. For additional information, refer to FRONT DISC BRAKE .
  6. Remove the bolt and the front wheel speed sensor.
    • To install, tighten to 9 Nm (80 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals