LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1007 (Anti-Lock Brake System -- F150 Pickup) >> Removal And Installation >> Wheel Speed Sensor - Front, 4x2 >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 3 wheel speed sensor harness retainers.
  4. Remove the bolt and the wheel speed sensor.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals