Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Prior to the removal of the vehicle security module, it is necessary to upload the module configuration information to the diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, REFER to MODULE CONFIGURATION
.
- Remove the LH B-pillar trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
- Disconnect the 2 vehicle security module electrical connectors.
- Remove the 2 screws and the vehicle security module.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Download the module configuration information from the diagnostic tool into the new module. For additional information, REFER to MODULE CONFIGURATION .