Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Prior to the removal of the DSM, it is necessary to upload the module configuration information to the diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, REFER to MODULE CONFIGURATION
.
- Remove the driver seat. For additional information, REFER to SEATING .
- Remove the 2 DSM screws.
- To install, tighten to 7 Nm (62 lb-in).
- Disconnect the 4 DSM electrical connectors and remove the DSM.
- To install, reverse the removal procedure.
- Download the module configuration information from the diagnostic tool into the new module. For additional information, REFER to MODULE CONFIGURATION .