LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Hydraulic Brake System Actuation -- F150 Pickup) >> Removal And Installation >> Brake Pedal and Bracket >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The adjustable pedal assembly is shown, the fixed pedal assembly is similar.
  1. If equipped with adjustable pedals, position them to the full forward position.
  2. Remove the instrument panel steering column cover. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    3. NOTE: The accelerator pedal and the brake pedal must be in the same position before connecting the adjustable accelerator pedal cable.
  3. If equipped, disconnect the adjustable accelerator pedal cable from the accelerator pedal assembly and position it aside.
    4. CAUTION: The brake pedal must be connected in an at-rest position before removing the speed control deactivator switch, or damage to the switch will occur.
  4. If equipped, disconnect the speed control deactivator switch.
  5. Disconnect the stoplamp switch electrical connector.
  6. Remove the redundant self-locking clip cover and self-locking clip.
  7. Position the stoplamp switch, booster rod, and the bushing off the brake pedal.
  8. If equipped with adjustable pedals, disconnect the adjustable pedal motor electrical connector at the top of the bracket.
  9. Remove the 4 brake booster nuts.
    • To install, tighten to 25 Nm (18 lb-ft).
  10. Remove the 2 upper brake pedal bracket bolts and the brake pedal and bracket assembly.
    • To install, tighten to 25 Nm (18 lb-ft).
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals