Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Using a suitable suction device, drain the brake fluid reservoir.
Disconnect the brake fluid level switch electrical connector.

NOTE: Cap the brake lines and plug the master cylinder ports.

Disconnect the 2 brake lines from the master cylinder.
- To install, tighten to 17 Nm (13 lb-ft).
Remove the 2 master cylinder nuts.
- To install, tighten 25 Nm (18 lb-ft).
To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .