LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Fuel Injection Supply Manifold & Injectors >> Removal (3.8L - VIN 4)

Removal (3.8L - VIN 4)

  1. Ensure ignition switch is turned to OFF position. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Disconnect negative battery cable. Remove fuel supply line. See FUEL LINE CONNECTOR . Remove upper intake manifold. See UPPER INTAKE MANIFOLD .
  2. Disconnect 6 fuel injector electrical connectors. Disconnect electrical connector and vacuum hose from fuel pressure sensor. Remove 4 fuel injection supply manifold bolts. Separate wiring harness from fuel injection supply manifold. Remove fuel injection supply manifold and fuel injectors as a unit. Remove retaining clips and remove fuel injectors from fuel injection supply manifold and discard "O" rings.
scientia non olet · About LEMON Manuals