LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L V6 - VIN G & L >> Removal & Installation >> Camshaft Rear Seal >> Removal

Camshaft Rear Seal: Removal

  1. Remove water pump pulley shield. Rotate water pump drive belt tensioner clockwise to release drive belt tension. Remove water pump drive belt. Using Crankshaft Damper Remover (T58P-6316-D) and Water Pump Pulley Remover/Replacer Set (T94P-6312-AH), remove water pump drive pulley from front intake camshaft.
  2. Use Shaft Protector (T94P-6312-AH) and Seal Remover (T92C-6700-CH) to remove camshaft rear oil seal. Place shaft protector onto front intake camshaft. Insert seal remover between camshaft and camshaft seal. Pry against shaft protector to remove seal.
scientia non olet · About LEMON Manuals