LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 2.5L V6 - VIN G & L >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

  1. Using a feeler gauge and straightedge, inspect cylinder block deck surface warpage. Resurface cylinder block if deck warpage exceeds specification.
  2. Check cylinder bore diameter, out-of-round and taper. Cylinder bore is measured at 1/2" below top of cylinder block head surface and 1/2" above piston when at bottom of cylinder bore.
  3. Bore cylinder block if cylinder bore diameter, taper or out-of-round exceeds specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals