LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock/Traction Control >> Diagnostic Tests >> DTC C1165: Right Rear Wheel Speed Sensor Circuit Failure

DTC C1165: Right Rear Wheel Speed Sensor Circuit Failure

  1. Turn ignition off. Disconnect ABS control module connector. Turn ignition on. Measure voltage between ABS control module connector terminal No. 2 (White/Green wire) and ground. See WIRING DIAGRAMS . If voltage is present, repair White/Green wire. Clear DTCs. Repeat self-test. If no voltage is present, go to next step.
  2. Turn ignition off. Measure resistance between ABS control module connector terminal No. 2 (White/Green wire) and ground. If resistance is not infinite, go to next step. If resistance is infinite, go to step 4)  .
  3. Disconnect right rear ABS sensor connector. Measure resistance between either sensor connector terminal and ground. If resistance is not infinite, replace sensor. Clear DTCs. Repeat self-test. If resistance is infinite, repair White/Green wire. Clear DTCs. Repeat self-test.
  4. Turn ignition off. Measure resistance between White/Green and Brown/Green wire terminals of ABS control module connector. If resistance is 1000-1500 ohms, reconnect all connections. Clear DTCs. Repeat self-test. If DTC C1165 is retrieved, replace Hydraulic Control Unit (HCU). Repeat self-test. If no DTCs are retrieved, system is operating normally. If resistance is not 1000-1500 ohms, go to next step.
  5. Measure resistance across wheel speed sensor connector terminals. If resistance is 1000-1500 ohms, repair White/Green and/or Brown/Green wire. Clear DTCs. Repeat self-test. If resistance is not 1000-1500 ohms, replace wheel speed sensor. Clear DTCs. Repeat self test.
scientia non olet · About LEMON Manuals