LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Component Tests >> Relays >> High Beam & Low Beam Relays

High Beam & Low Beam Relays

  1. Remove relay to be tested. Check continuity between terminals No. 3 and 5 of relay. See Fig 1 . If continuity does not exist, go to next step. If continuity exists, replace relay.
  2. Apply battery voltage between terminals No. 1 and 2 of relay. With battery voltage applied continuity should now exist between terminals No. 3 and 5. If continuity is as specified, relay is okay at this time. If continuity is not as specified, replace relay.
Fig 1: Identifying High Beam & Low Beam Relay Terminals
G97J28141Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals