LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Crankshaft Front Oil Seal >> Removal

Crankshaft Front Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.

Raise and support vehicle. Remove right front wheel assembly. Remove right splash shield. Remove accessory drive belt. Remove crankshaft pulley retaining bolt and washer. Using Crankshaft Damper Remover (T58P-6316-D), remove crankshaft pulley from crankshaft. Using Seal Remover (T92C-6700-CH), remove crankshaft oil seal from front cover.

scientia non olet · About LEMON Manuals