LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Camshaft Rear Seal >> Installation

Camshaft Rear Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply engine oil to new oil seal. Using Power Steering Pump Pulley Replacer (T91P-3A733-A), Camshaft Seal Protector (T94P-6256-AH) and Camshaft Seal Replacer (T94P-6256-BH), install camshaft rear oil seal.
  2. Using power steering pump pulley replacer, Replacer Cup (T94P-6312-AH) and Screw (T94P-6312-AH), install water pump drive pulley. Rotate water pump drive belt tensioner clockwise. Install water pump drive belt. Release drive belt tensioner slowly. Install water pump pulley shield.
scientia non olet · About LEMON Manuals