LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Overhaul >> Cylinder Block Assembly >> Fitting Main Bearings

Fitting Main Bearings

WARNING: This page is about a different variant/trim than selected.
  1. Check main bearing surfaces for wear and damage. Use Plastigage method for checking bearing clearance. Check all bearings at the same time. If clearance is not to specification, replace bearings until proper clearance is reached.
scientia non olet · About LEMON Manuals