LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Engine Oiling >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove oil pump screen cover and tube. Remove front cover. See FRONT COVER  under REMOVAL & INSTALLATION. Remove timing chain and crankshaft sprocket. See TIMING CHAINS  under REMOVAL & INSTALLATION.
  2. Remove oil pump retaining bolts following sequence shown. See Fig 1. Remove oil pump from cylinder block.
Fig 1: Oil Pump Retaining Bolt Removal Sequence
G95A14456Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals