System Tests: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
After completing diagnostic tests or any repair, clear DTCs and perform quick test. See CLEARING DIAGNOSTIC TROUBLE CODES and QUICK TEST
under DIAGNOSIS & TESTING.
NOTE:
Procedures in SYSTEM TESTS are written for the use of the following Ford Motor Co. test equipment:
- New Generation Star (NGS) Tester (007-00500)
- Breakout Box (014-00950)
- Transmission Tester (007-0085D)
Terminal pin references are based on this equipment and appropriate overlays. All references to "test pins", "test terminals" or "jacks" refer to test equipment. When aftermarket test equipment is used, always follow test equipment manufacturer's procedures.