LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - System & Engine Component Tests - EEC-V (Bi-Fuel & Natural Gas)) >> Fuel System (Natural Gas Vehicles) >> Leak Test (LPG) >> Fuel Injection Supply Manifold & Fuel Injectors

Fuel Injection Supply Manifold & Fuel Injectors

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel pump relay from battery junction box located in engine compartment. Connect a jumper wire between fuel pump relay harness connector terminals No. 87 and 30. See Fig 1. Remove the jumper wire. Install the fuel pump relay into battery junction box.
    Fig 1: Identifying Fuel Pump Relay Harness Connector Terminals
    G97J28125Courtesy of FORD MOTOR CO.
  2. Check the spring lock coupling and the fuel injection supply manifold to fuel injector connections for leaks, using the combustible gas detector. If a leak is detected, verify the connection is engaged properly, then retest. If the leak remains, repair as necessary and retest.
scientia non olet · About LEMON Manuals