LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Power Steering System -- F150 Pickup) >> Removal And Installation >> Power Steering Pump >> Installation

Power Steering Pump: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Using the special tool, install a new Teflon® seal on the pressure line fitting.
    Fig 1: Using Special Tool To Install New Teflon® Seal On Pressure Line Fitting
    G03961376Courtesy of FORD MOTOR CO.

    2. 4.6L, 5.4L engines 

  2. Position the power steering pump and install the 3 bolts.
    • Tighten to 25 Nm (18 lb-ft).

    3. 4.2L engine 

  3. Position the power steering pump and install the 4 bolts.
    • Tighten to 25 Nm (18 lb-ft).

    4. All vehicles 

  4. Position the high pressure line and connect the fitting to the power steering pump.
    • If equipped with a 4.6L or 5.4L engine, tighten to 65 Nm (48 lb-ft).
    • If equipped with a 4.2L engine, tighten to 20 Nm (15 lb-ft).
  5. Connect the suction line and install the clamp.
  6. Install the power steering pump pulley. For additional information, refer to POWER STEERING PUMP PULLEY .
scientia non olet · About LEMON Manuals