LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 989 (Engine System-General Information -- F150 Pickup) >> General Procedures >> Camshaft End Play - OHC Engines

Camshaft End Play - OHC Engines

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART

G03878636
 Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) or equivalent
  1. Use a Dial Indicator Gauge with Holding Fixture to measure camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the indicator.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install new camshaft and recheck end play.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head.
    Fig 1: Using Dial Indicator Gauge With Holding Fixture To Measure Camshaft End Play
    G03885002Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals