LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 986 (Engine - 4.2L -- F150 Pickup) >> In-Vehicle Repair >> Engine Dynamic Balance Shaft >> Installation

Engine Dynamic Balance Shaft: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the engine dynamic balance shaft with clean engine oil and install it in the engine block.
  2. Install the bolts.
    • Tighten to 12 Nm (9 lb-ft).
  3. Make sure the engine dynamic balance shaft Woodruff key is at the 12 o'clock position and the camshaft Woodruff key is at the 6 o'clock position.
  4. Install the engine dynamic balance shaft drive gear on the camshaft. Make sure the timing marks on the drive gear and driven gear are lined up.
    Fig 1: Identifying Timing Marks On Drive Gear And Driven Gear Are Alined
    G03962042Courtesy of FORD MOTOR CO.
  5. Install the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
scientia non olet · About LEMON Manuals