LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 986 (Engine - 4.2L -- F150 Pickup) >> In-Vehicle Repair >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a bead of silicone gasket and sealant to the keyway in the crankshaft damper and use the special tool to install the crankshaft damper.
    Fig 1: Installing Crankshaft Damper
    G03962005Courtesy of FORD MOTOR CO.
  2. Using the special tool to prevent crankshaft rotation, install the bolt.
    • Tighten to 160 Nm (118 lb-ft).
    Fig 2: Installing Crankshaft Bolt
    G03962003Courtesy of FORD MOTOR CO.
  3. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Install the fan blade assembly. For additional information, refer to ENGINE COOLING .
  5. Install the drive belt. For additional information, refer to ACCESSORY DRIVE .
scientia non olet · About LEMON Manuals