LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Variable Camshaft Timing (VCT) Oil Control Solenoid - 5.4L (3V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

    Both sides 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .

    2. LH side 

  2. Remove the 3 bolts and position the power steering fluid reservoir aside.
    • To install, tighten to 11 Nm (8 lb-ft).
    Fig 1: Removing Power Steering Fluid Reservoir Bolts
    G03933612Courtesy of FORD MOTOR CO.

    3. Both sides 

  3. Disconnect the variable camshaft timing (VCT) oil control solenoid electrical connector.
  4. Remove the grommet.
  5. Remove the bolt and the VCT oil control solenoid.
    • To install, tighten to 5 Nm (44 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals