Catalyst Monitor Sensor - 4.6L (2V) and 5.4L (3V)
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CATALYST MONITOR SENSOR - 4.6L (2V) and 5.4L (3V) SPECIAL TOOL
| Socket, Exhaust Gas Oxygen Sensor 303-476 (T94P-9472-A) |
MATERIAL REFERENCE
| Item | Specification |
|---|---|
| Penetrating and Lock Lubricant XL-1 (in Canada CXC-51-A) | - |
| High Temperature Nickel Anti-Seize Lubricant XL-2 or equivalent | ESE-M12A4-A |
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Using the special tool, remove the catalyst monitor sensor.
- To install, tighten to 46 Nm (34 lb-ft).
- To install, reverse the removal procedure.
- Apply anti-seize to the threads of the catalyst monitor sensor.
NOTE:
If necessary, lubricate the catalyst monitor sensor with penetrating and lock lubricant to assist in removal.