Cooling Fan - Blade, Clutch and Shroud

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL DESCRIPTION

	Wrench, Fan Clutch Nut 303-240 (T84T-6312-D)
	Holding Wrench, Fan Pulley 303-239 (T84T-6312-C)

Fig 1: Exploded View Of Cooling Fan - Shroud

Courtesy of FORD MOTOR CO.

Fig 2: Exploded View Of Cooling Fan - Blade And Clutch

Courtesy of FORD MOTOR CO.

All vehicles

Remove the pin-type retainers and the radiator appearance cover.

Fig 3: Removing Pin-Type Retainers And Radiator Appearance Cover
Courtesy of FORD MOTOR CO.

Vehicles equipped with a 4.2L or 4.6L (2V) engine

Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .

Vehicles equipped with a 5.4L (3V) engine

Remove the air cleaner intake pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Remove the bolts and the air cleaner bracket.
- To install, tighten to 10 Nm (89 lb-in).
Fig 4: Removing Bolts And Air Cleaner Bracket
Courtesy of FORD MOTOR CO.

Vehicles equipped with a 4.6L (2V) or 5.4L (3V) engine

Detach the battery cable harness from the radiator shroud.

Fig 5: Detaching Battery Cable Harness From Radiator Shroud
Courtesy of FORD MOTOR CO.

All vehicles

Using the special tools, remove the cooling fan assembly and position it in the fan shroud.
- To install, tighten to 55 Nm (41 lb-ft).
Fig 6: Using Special Tools To Remove Cooling Fan Assembly And Position It In Fan Shroud
Courtesy of FORD MOTOR CO.
Remove the bolts and the fan shroud and fan.
- To install, tighten to 6 Nm (53 lb-in).
If necessary, remove the bolts and separate the fan and the fan clutch.
- To install, tighten to 17 Nm (13 lb-ft).
To install, reverse the removal procedure.