LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 980 (Fuel System & Engine Controls - 4.2L -- F150 Pickup) >> Removal And Installation >> Fuel Injectors >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions may result in personal injury.
  1. Remove the fuel rail. For additional information, refer to FUEL RAIL .
  2. Remove the fuel injectors.
  3. Remove and discard the fuel injector O-ring seals.
    Fig 1: Removing Fuel Injector O-Ring Seals
    G03885875Courtesy of FORD MOTOR CO.
    4. NOTE: Lubricate the new O-ring seals with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals