LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 980 (Fuel System & Engine Controls - 4.2L -- F150 Pickup) >> Removal And Installation >> Fuel Charging Wiring Harness >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
  1. Remove the upper intake manifold. For additional information, refer to ENGINE - 4.2L .
  2. Disconnect the fuel charging wiring harness-to-main engine wiring harness electrical connector.
  3. Disconnect the intake manifold runner control (IMRC) actuator electrical connector.
  4. Disconnect the 6 fuel injector electrical connectors.
  5. Disconnect the 2 wiring harness retainers.
  6. Remove the wire tie.
    Fig 1: Removing Wire Tie
    G03982117Courtesy of FORD MOTOR CO.
  7. Disconnect the fuel rail pressure sensor electrical connector.
  8. Remove the fuel charging wiring harness.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals