LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Automatic Transmission -- F150 Pickup) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the output shaft speed (OSS) sensor electrical connector.
  3. Remove the OSS sensor bolt and sensor.
    • Remove the OSS sensor bolt.
    • Remove the OSS sensor.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals