LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Automatic Transmission -- F150 Pickup) >> In-Vehicle Repair >> Digital Transmission Range (TR) Sensor >> Installation

Digital Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the digital TR sensor and loosely install the bolts.
    Fig 1: Installing Digital TR Sensor And Loosely Install Bolts
    G03888527Courtesy of FORD MOTOR CO.
  2. Using the special tool, align the digital TR sensor slots. The tool is designed to fit snug.
    Fig 2: Aligning Digital TR Sensor Slots Using Special Tool
    G03888628Courtesy of FORD MOTOR CO.
    3. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
    Fig 3: Digital TR Sensor Bolts - With Torque Specifications
    G03929639Courtesy of FORD MOTOR CO.
  3. Tighten the bolts.
  4. Install the manual control lever.
    1. Install the lever.
    2. Install a new nut.
    Fig 4: Installing Manual Control Lever
    G03929756Courtesy of FORD MOTOR CO.
  5. With the manual control lever in NEUTRAL, connect the shift control cable.
    Fig 5: Identifying Manual Control Lever Shift Cable End (NEUTRAL)
    G03888604Courtesy of FORD MOTOR CO.
  6. Install the digital TR electrical connector.
    Fig 6: Installing Digital TR Electrical Connector
    G03929749Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals