LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine - 5.4L (3V) - F150 Pickup) >> In-Vehicle Repair >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
  2. Remove the RH variable camshaft timing (VCT) oil control solenoid. For additional information, refer to ELECTRONIC ENGINE CONTROLS .
  3. Remove the powertrain control module (PCM) and bracket. For additional information, refer to ELECTRONIC ENGINE CONTROLS .
  4. Remove the RH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L (3V) .
  5. Remove the nut and disconnect the A/C compressor manifold tube.
    • Discard the O-ring seals.
  6. Disconnect the quick connect couplings and remove the crankcase ventilation tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  7. If equipped, disconnect the vacuum tube.
    Fig 1: Disconnecting Vacuum Tube
    G03962983Courtesy of FORD MOTOR CO.
  8. Detach the engine harness retainer and position the harness aside.
    Fig 2: Detaching Engine Harness Retainer And Position Harness Aside
    G03962984Courtesy of FORD MOTOR CO.
  9. Remove the battery cover.
  10. Remove the 2 suction accumulator nuts and position the suction accumulator aside.
    Fig 3: Removing Suction Accumulator Nuts
    G03962985Courtesy of FORD MOTOR CO.
  11. Remove the transmission fluid level indicator tube retaining bolt and position the fluid indicator tube aside.
    Fig 4: Removing Transmission Fluid Level Indicator Tube Retaining Bolt
    G03964058Courtesy of FORD MOTOR CO.
    12. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
    NOTE: The bolts are part of the valve cover and should not be removed.
  12. Loosen the 14 fasteners and remove the RH valve cover and gasket.
    • Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
    • Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
scientia non olet · About LEMON Manuals