LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine - 5.4L (3V) - F150 Pickup) >> In-Vehicle Repair >> Valve Cover - LH >> Removal

Valve Cover - LH: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner intake pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Remove the LH ignition coils. For additional information, refer to ENGINE IGNITION - 5.4L (3V) .
  3. Remove the oil level indicator and tube. For additional information, refer to OIL LEVEL INDICATOR AND TUBE .
  4. Remove the bolt and the nut and position the power steering reservoir and bracket assembly aside.
  5. Disconnect the quick connect couplings and remove the positive crankcase ventilation (PCV) tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  6. Disconnect the intake manifold vacuum tube hose from the brake booster.
  7. Disconnect the intake manifold vacuum tube from the support bracket and the valve cover stud.
  8. Disconnect the radio ignition interference capacitor electrical connector.
  9. Disconnect the variable camshaft timing (VCT) solenoid electrical connector and the wiring harness retainers.
    10. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
    NOTE: The bolts are part of the valve cover and should not be removed.
  10. Loosen the 15 fasteners and remove the LH valve cover and gasket.
    • Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
    • Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
scientia non olet · About LEMON Manuals