LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Engine - 4.6L (2V) - F150 Pickup) >> In-Vehicle Repair >> Valve Seals >> Installation

Valve Seals: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The 3 rearmost valve seals on the RH side must use special tool 303-567 in the same manner as is shown in the illustration.
    NOTE: Lubricate the valve seal with clean engine oil prior to installation.
    Fig 1: Using Special Tools To Install New Valve Stem Seal
    G03947669Courtesy of FORD MOTOR CO.
  1. Using the special tools, install the new valve stem seal.
  2. Install the valve springs. For additional information, refer to VALVE SPRINGS .
scientia non olet · About LEMON Manuals