Oil Pump: Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging.
- Install the oil pump and loosely install the 3 bolts in the sequence shown.
- Tighten to 10 Nm (89 lb-in).
- Install the oil pump screen and pickup tube and the 3 bolts.
- Tighten to 25 Nm (18 lb-ft).
- Tighten to 10 Nm (89 lb-in).
- Install the oil pan. For additional information, refer to OIL PAN .
- Install the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
CAUTION:
Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
CAUTION:
Make sure the O-ring is in place and not damaged. A missing or damaged O-ring can cause foam in the lubrication system, low oil pressure and severe engine damage.
NOTE:
Install a new O-ring seal and lubricate with clean engine oil.