LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Engine - 4.6L (2V) - F150 Pickup) >> In-Vehicle Repair >> Camshaft >> Installation

In-Vehicle Repair: Camshaft: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the camshaft and the camshaft bearing caps in their original locations.
    • Lubricate the camshaft with clean engine oil.
    • Position the camshaft.
    • Lubricate the camshaft bearing caps with clean engine oil.
    • Position the camshaft bearing caps.
    • Install the bolts loosely.
    Fig 1: Installing Camshaft And Camshaft Bearing Caps In Their Original Locations
    G03885383Courtesy of FORD MOTOR CO.
    2. NOTE: LH shown, RH similar.
    Fig 2: Identifying Tightening Sequence Of Bolts
    G03962481Courtesy of FORD MOTOR CO.
  2. Tighten the bolts in the sequence shown.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the special tools on the camshaft being serviced.
    Fig 3: Installing Special Tools On Camshaft Being Serviced
    G03962737Courtesy of FORD MOTOR CO.
  4. Install the camshaft sprocket spacer, camshaft sprocket, washer and bolt onto the camshaft being serviced. Tighten the camshaft sprocket bolt in 2 stages:
    • Stage 1: Tighten to 40 Nm (30 lb-ft).
    • Stage 2: Tighten an additional 90 degrees.
  5. Install the special tool between the valve spring coils to protect the valve stem seal from damage.
    Fig 4: Installing Special Tool Between Valve Spring Coils To Protect Valve Stem Seal From Damage
    G03962476Courtesy of FORD MOTOR CO.
    6. NOTE: The camshaft roller followers must be installed in their original locations.
    NOTE: The 3 rearmost camshaft roller followers on the RH side must use special tool 303-567 in the same manner as is shown in the illustration.
    NOTE: Lubricate the camshaft roller follower with clean engine oil prior to installation.
    Fig 5: Using Special Tool To Compress Valve Spring And Install Camshaft Roller Follower
    G03962484Courtesy of FORD MOTOR CO.
  6. Using the special tool, compress the valve spring and install the camshaft roller follower.
    • Install all of the camshaft roller followers onto the camshaft being serviced.
  7. Install the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
scientia non olet · About LEMON Manuals