LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Safety Belt System -- F250-F550 Super Duty) >> Removal And Installation >> Child Safety Seat Tether Anchor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    SuperCab vehicles 

  1. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from the vehicle.
    Fig 1: Removing Seat Backrest
    G03925419Courtesy of FORD MOTOR CO.

    2. Regular cab vehicles 

  2. Position the front seat(s) forward.

    Crew Cab vehicles 

  3. Position the rear seats forward.

    4. Regular and Crew Cab vehicles 

    NOTE: RH side shown, all others similar.
    Fig 2: Child Safety Seat Tether Anchor Bolt Torque Specification (Regular And Crew Cab Vehicles)
    G03926190Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the child safety seat tether anchor.

    5. SuperCab vehicles 

    NOTE: RH side shown, all others similar.
    Fig 3: Child Safety Seat Tether Anchor Bolt Torque Specification (Supercab Vehicles)
    G03926191Courtesy of FORD MOTOR CO.
  5. Remove the bolt and the child safety seat tether anchor.

    6. All vehicles 

    WARNING: It is important that the bolt/anchor be securely tightened to specification. Otherwise, the child's safety seat may not be correctly secured, and the child can be injured in case of a sudden stop or accident.
  6. To install, reverse the removal procedure.
    • See the REMOVAL PROCEDURE  or SPECIFICATIONS  for torque specifications.
    • For SuperCab, after seat backrest installation, make sure the child safety seat tether anchor strap is accessible and not trapped between the seat backrest and cab back panel.
  7. Check the active restraint system for correct operation.
scientia non olet · About LEMON Manuals