LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 957 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All seats 

  1. Remove the seat. For additional information, refer to FRONT SEAT - CAPTAIN'S CHAIR AND 40 PERCENT  in this article.
  2. Remove the lumbar knob.
    Fig 1: Removing Lumbar Knob
    G03911409Courtesy of FORD MOTOR CO.
  3. Remove the seat backrest lever.
    Fig 2: Removing Seat Backrest Lever
    G03911410Courtesy of FORD MOTOR CO.
  4. Remove the screws.
    Fig 3: Removing Screws
    G03911411Courtesy of FORD MOTOR CO.
  5. Remove the pin-type retainer.
    Fig 4: Removing Pin-Type Retainer
    G03911412Courtesy of FORD MOTOR CO.
  6. Remove the screws.
    Fig 5: Removing Screws
    G03911413Courtesy of FORD MOTOR CO.
  7. Remove the screws.
    Fig 6: Removing Screws
    G03911414Courtesy of FORD MOTOR CO.
  8. Vehicles with heated seats 

  9. Disconnect heated seat switch electrical connector.
    Fig 7: Locating Heated Seat Switch Electrical Connector
    G03911415Courtesy of FORD MOTOR CO.
  10. All seats 

  11. Disconnect the electrical connector and remove the seat control switch.
    Fig 8: Removing Seat Control Switch
    G03911416Courtesy of FORD MOTOR CO.
  12. To install, reverse the removal procedure.