LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 954 (Body Panel System - General Information -- F250-F550 Super Duty) >> Diagnosis And Testing >> Body System >> Inspection and Verification >> Leaks

Inspection and Verification: Leaks

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The trim will reveal the location of most leaks. Use spray chalk and a hose if necessary.
  1. Remove any trim or carpet in the general area of the leak.
  2. Road test or water hose test the vehicle.
  3. Inspect for a dust pattern around the area in question. Inspect for water paths near and above the area in question.
  4. Some leaks can be located by placing bright light under the vehicle, removing any necessary trim or carpet, and inspecting the interior of the body at joints and weld lines.
scientia non olet · About LEMON Manuals