LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Antenna System -- F250-F550 Super Duty) >> Removal And Installation >> Antenna Lead-In Cable >> Installation

Antenna Lead-In Cable: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the new radio antenna lead-in cable into the passenger compartment.
    • Make sure the grommet is fully seated
      Fig 1: Routing Radio Antenna Lead-In Cable Into Passenger Compartment
      G03924950Courtesy of FORD MOTOR CO.
  2. Route and secure the new antenna lead-in cable to the instrument panel reinforcement.
  3. Install the audio unit. For additional information, refer to AUDIO UNIT .
  4. Install the pin-type retainer and the lower RH A-pillar trim panel.
    Fig 2: Installing Pin-Type Retainer And Lower RH A-Pillar Trim Panel
    G03924949Courtesy of FORD MOTOR CO.
  5. Route the antenna cable through the antenna base opening on the cowl.
  6. Position the RH front fender splash shield to the bulkhead.
    1. Install the 2 nuts.
    2. Install the screws.
    3. Install the pin-type retainers.
      Fig 3: Positioning RH Front Fender Splash Shield To Bulkhead
      G03924953Courtesy of FORD MOTOR CO.
  7. Install the antenna base. Refer to ANTENNA BASE  in this article.
scientia non olet · About LEMON Manuals