LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 947 (Warning System -- F250-F550 Super Duty) >> General Procedures >> Belt Minder Deactivating/Activating >> Deactivating/Activating

Belt Minder Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the RUN position. (Do not start the engine.)
  2. Wait until the safety belt warning indicator turns off (approximately 1 minute).
    3. NOTE: Step 3 must be completed within 60 seconds after the safety belt warning indicator turns off.
    After the step the safety belt warning indicator illuminates for 3 seconds.
  3. Buckle and unbuckle the safety belt 9 times, ending with the safety belt unbuckled.
    4. NOTE: Carry out this step within 10 seconds after the safety belt warning indicator is illuminated.
  4. Buckle and unbuckle the safety belt.
  5. The following sequence of events confirm the belt minder is enabled:
    • flashing of the safety belt warning indicator 4 times per second for 3 seconds
    • 3 seconds with the safety belt warning indicator off
    • flashing the safety belt warning indicator 4 times per second for 3 seconds again
  6. The safety belt warning indicator flashing 4 times per second for 3 seconds provides confirmation of belt minder disabled.
  7. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals