Fuel Injection Supply Manifold & Fuel Injectors
WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford Econoline, 2002 Ford Cutaway, and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Remove fuel pump (valve) relay. See FUEL PUMP RELAY LOCATION table. Connect a jumper wire between fuel pump relay cavities No. 30 and 87. See Fig 1. This will cause tank valves to open and pressurize fuel system. Remove jumper wire and go to next step.FUEL PUMP RELAY LOCATION
Application Location Crown Victoria In Relay Center Box No. 1, On Left Side Wheelwell In Engine Compartment Econoline In Battery Junction Box, On Left Side Of Engine Compartment F150 In Battery Junction Box, On Rear Left Side Of Engine Compartment - Reinstall fuel pump relay. Using Combustible Gas Detector (134-00049), check spring lock coupling and fuel injection supply manifold to fuel injector connections for leaks. If a leak is detected, verify connection is engaged properly, then retest. If leak remains, repair as necessary and retest.
NOTE:
On Crown Victoria, fuel pump relay is referred to as the fuel valve relay.