LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Electronic Engine Control System -- Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Barometric Pressure (BARO) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
    2. CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab can occur.
  2. Remove the instrument panel steering column cover.
    1. Unlock the retainers.
    2. Remove the instrument panel steering column cover.
      Fig 1: Removing Instrument Panel Steering Column Cover
      G03905219Courtesy of FORD MOTOR CO.
  3. Remove the barometric pressure (BARO) sensor.
    • Disconnect the BARO sensor electrical connector.
    • Release the clip and remove the BARO sensor.
      Fig 2: Removing Barometric Pressure (BARO) Sensor
      G03908133Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals