Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the upfitter switch. For additional information, refer to UPFITTER SWITCH in this article.
Lower the glove compartment.
1. Open the glove compartment.
2. While releasing the glove compartment stops, lower the glove compartment.
  
  Fig 1: Releasing Glove Compartment Stops Lower Glove Compartment
  Courtesy of FORD MOTOR CO.
Remove the 2 screws and position the upfitter relay box aside.

Fig 2: Removing Screws And Position Upfitter Relay Box Aside
Courtesy of FORD MOTOR CO.
Release the 2 tabs and remove the upfitter relay box from the bracket.

Fig 3: Releasing Tabs And Remove Upfitter Relay Box From Bracket
Courtesy of FORD MOTOR CO.
Remove the instrument panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Remove the ground screw.

Fig 4: Identifying Connector & Ground Screw
Courtesy of FORD MOTOR CO.
Release the wiring harness locators and remove the upfitter relay box.
To install, reverse the removal procedure.