LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Removal, Overhaul & Installation - F150 Pickup - NGV) >> Fuel Systems >> Fuel Tank >> Removal & Installation (Front In-Bed Tank)

Removal & Installation (Front In-Bed Tank)

WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove in-bed tank assembly cover. Disconnect electrical connector, high-pressure fuel line, and jumper fuel line from bed mounted fuel tank solenoid valve. Place identification marks on upper bed mounted tank straps and tank. Remove upper in-bed fuel tank straps. Position Floor Crane (014-00072), Separator Lift Bar (303-F054), and Lifting Sling (100-D008) over fuel tank. Carefully raise fuel tank assembly from vehicle.
  2. To install, reverse removal procedure. Lubricate NEW "O" rings with 5W-30 engine oil. Align the identification marks on the upper in-bed fuel tank straps and tank. After installation is complete, natural gas fuel lines must be leak tested. Perform COMPRESSED NATURAL GAS LEAK TEST under FUEL SYSTEMS in SYSTEM & COMPONENT TESTING - EEC-V - NGV article.
scientia non olet · About LEMON Manuals